Hi if you are using the ACC-2 connector to interface with your multi-mode
controller, you may have had a problem with your transmitted audio signal
being distorted, to eliminate this see bellow.
This modification should not affect any of the other normal operations of the
Set your meter on the radio to read ALC
PK232 OWNERS: if alsso using a VHF tranceiver, adjust the AFSK level for
proper VHF operation as expalained in chapter 3 of the operating manual.If not
adjust for proper SSB operation.
DSP - 1232 / DSP - 2232 Owners: Adjust the appropriate AFSK level control for
proper SSB operation as expalined in chapter 3 of the operating manual.
Place the TNC in calibrate mode and press K to key the radio.
Adjust VR-13 on the TS-450 or VR-18 on the TS-850 so that the meter
"Just comes off the peg" as described in the section titled "SSB Tranciever
Final Adjustments" (in the TNC operating manual).
Press Q to quit the CALIBRATE mode